最近最经典中文MV字幕,国产成人无码精品久久二区三,在线一区二区三区,四川少妇BBB搡BBB爽爽爽视频

In the pig farm, we can often see tall feed towers, which can help us solve the problem of feed. Feed towers provide feed to every pig house through feed pipes, but we will find that in some cases, the feed pipes are always blocked, so how should we solve the problem of blocking?
First of all, let's understand the causes of the blockage. Generally, the blockage is caused by the poor transportation of the metering tube of the electronic scale. The poor transportation of materials in the metering tube or the long time of material accumulation in the metering tube will lead to the difficulty of material unloading and the formation of the metering tube limit plug. The synchronous mechanical transmission system or electrical DC speed governing board control of the electronic scale and the feeding tower presents running fault, which causes the feeding out of synchronization and blockage. Secondly, it may be caused by the blockage of the blanking hood and the feed inlet. During the feeding operation, pay attention to the investigation of the operation and stop the machine immediately if the blanking inlet is found to be blocked. It can be concluded that the feeding fault of the tower system is caused by the unstable flow separation or no flow signal of the electronic scale, which is caused by the improper adjustment of the photoelectric switch and the rake roller.
So how can we solve these problems? First of all, we should check the working condition of the photocell, adjust the position of the photocell, readjust the gap between the rake roller and the lifting belt, and control the feeding height under the condition of ensuring the flow of the production line. Then repair the mechanical transmission system or electrical speed governing board fault parts, so that the material tower and electronic scale run six steps. Secondly, it is also necessary to open the maintenance observation window to check whether the blanking at the blanking port is smooth, and carry out local transformation. Check whether the connection between the blanking port and the metering pipe is reasonable and whether the design angle of the chute of the hopper is correct.
It's normal that the feed tower is blocked. If the feed density is too large or too small, it may cause the pipe blockage of the feed tower. As long as we find the blockage in time and solve the blockage problem.